WAYJUN Hot products:8AI, 4DI, 4DO Mixed Signal RS-485/232, Modbus Data Acquisition Module WJ30
Features:
● Eight Road 4-20mA Enter MODBUS RTU Communication Agreement
● Four switch input, four switch output
● Proficiency of calibration module can be accessed through the RS-485/232 interface
● Signal input / output isolation with pressure 3000VDC
● Wide power supply range: 8 ~ 32VDC
● High reliability, convenient programming, easy to apply
● Standard DIN35 rail installation, convenient centralized wiring
● User settings set address, baud rate, etc.
● Support MODBUS RTU communication protocol, automatic identification protocol
● Regulation, small volume preset design
typical application:
● Signal measurement, monitoring and control
● RS-485 remote I / O, data collection
● Intelligent building control, security engineering and other application systems
● RS-232/485 bus industrial automation control system
● Industrial field signal isolation and long-term transmission
● Equipment operation monitoring
● Measurement of sensor signals
● Acquisition and record of industrial field data
● Medical, industrial control product development
● 4-20mA or 0-5V signal acquisition
product description:
WJ30 product implements signal acquisition between sensors and hosts to detect analog signals. WJ30 series products can be applied to the RS-232/485 bus industrial automation control system, 4-20mA / 0-5V signal measurement, monitoring adsorbed clause: control, and industrial field signal isolation and long-term transmission, etc.
Products include power isolation, signal isolation, linearization, A / D conversion, and RS-485 serial communication. Each serial port can be connected up to 25 5 WJ30 series modules, communication mode supports modbus RTU communication protocol, minimum address is 01, Baudi 9600, data format: 10 digits, 1 start position, 8 digits, 1 bit Stop bit, no reset. Also supports the ASCII code communication protocol, baud rate coding settings, can be hung on the same RS-485 bus with other manufacturers, available for computer programming.
WJ30 series products are based on a single-chip intelligent monitoring and control system, all user-set calibration values, address, baud rates, data formats, correction, and status, configuration information, etc., are stored in the insertion memory EEPROM.
Working temperature range - 45 ° C ~ +85 ° C. WJ30 series products are isolated from industrial standards, manufacturing, signal input / output, can withstand 3000VDC isolation voltages, strong anti-interference ability, high reliability.
WJ30 universal parameters:
(Typical @ + 25 ° C, VS is 24VDC)
Analog input: current input / voltage input
Essence: 0.1%
Temperature drift: ± 50 ppm / ° C (± 100 ppm / ° C, maximum)
Input resistance: 100Ω (4-20mA / 0-20mA / 0-10MA current input)
                         2kΩ (0-1MA current input)
                         More than 200K (5V / 10V voltage input)
Bandwidth: -3 dB 10 Hz
AD conversion rate: 10 SPS (factory default value, user can send a command to modify the conversion rate.)
                AD conversion rates can be set by 40204 registers 2.5 SPS, 5 SPS, 10 SPS, 20 SPS, 40 SPS, 80 SPS, 160 SPS, 320 SPS, 500 SPS, 1000 SPS. (Channel conversion rate = AD conversion rate / open channel number)
Switch input: 4 channels (DI0 ~ DI3).
             Low level: Enter <1V
             High level: input 4 ~ 30V
Input resistance: 3kΩ
Switching output: The collector opening output, voltage 0 to 30 V, maximum load current 30mA, 4 channels (DO0 to DO3).
Analog output: voltage is 0 to 4.8V, and the output load is greater than 2k ohm.
Communication: Protocol RS-485 or RS-232 Standard Character Protocol and Modbus RTU Communication Agreement
             Porter rate (2400, 4800, 9600, 19200, 38400, 57600, 115200 bps) can be available
Address (0 ~ 255) can be software selection
Communication Response Time: 100 MS Max
Working power supply: +8 ~ 32VDC wide power supply range, there is anti-reverse and overvoltage protection circuit
Power consumption: less than 2W
Work temperature: - 45 ~ + 80 ° C
Work humidity: 10 ~ 90% (no condensation)
Storage temperature: - 45 ~ + 80 ° C
Storage humidity: 10 ~ 95% (no condensation)
Isolation, pressure: analog signal and switch signal 3000V isolation, switch quantity signal, and power supply.
Dimensions: 120 mm x 70 mm x 43mm

Write a review

Note: HTML is not translated!
    Bad           Good

8AI, 4DI, 4DO Mixed Signal RS-485/232, Modbus Data Acquisition Module WJ30

  • Product Code: WJ30
  • Availability: In Stock
  • $74.99

  • Ex Tax: $74.99